Fukagawa Lab Patented Product Mikoshi Geta Asanoha

This is a patented product from Fukagawa Lab.
Purchased in the summer of 2025 and used only once (for about 1 hour).
It is clean with no dirt or damage.
I am selling it because I no longer use it. I hope someone who is looking for this will use it.
Below is an excerpt from the homepage.

The Fukagawa Lab's Kizuna Mark (Bond Mark) is attached as a point.
Most Mikoshi Geta are made by carving a block of wood. This was developed in response to feedback about corners hitting or pinching and causing pain.

At Fukagawa Lab, we have created an adjuster that is lightweight, does not hurt your shoulders, and allows people who couldn't reach the weight with the shoulder rest to properly feel the weight and carry it.

Urethane is set on both sides of the wood. The surface has an original cut to distribute weight.
The exterior has a double cloth cover.
The outer cover can be removed and washed.
Pass the string through the two holes at each end of the wooden part and hang it on your shoulder.
It is about 10 cm thick and surprisingly light, weighing approximately 300g.

Once you get used to it, I believe it will become a good companion.