DREMEL MICRO Dremel Battery Mini Router (Cordless)

This is a DREMEL MICRO 8050-N/18 cordless mini rotary tool.

It has been stored at home and has been used very little.
The main unit is clean with no noticeable scratches or dirt.
The charger has a scratch as if solder was applied, but it does not affect its use. Please check the photos.
Charging confirmed, power and speed adjustment operations confirmed.

Immediate purchase is OK.
We will prioritize the buyer who completes the purchase procedure, even if there are comments.

Please refer to the information below from the internet.

[Model] DREMEL MICRO 8050-N/18
This product was discontinued in February 2021.

[Product Features]
- Cordless, equipped with a 7.2V lithium-ion battery!
- Independent ON/OFF switch: Located at the tip for easy operation.
- Shaft lock button: Allows for quick and easy accessory changes.
- LED lamp: Equipped with a 4-light LED lamp.
- Rubber grip: A non-slip rubber grip that allows for good maneuverability in detailed work due to its close proximity to the accessory.
- Overload protection device: Automatically stops the motor when an excessive load is applied.
- Speed display LED lamp: Equipped with an LED lamp that allows you to check the 5-speed rotation speed at a glance.
- Keep it on the docking station (charger) for a full charge at any time!

[Specifications and Dimensions]
Overall length (mm): 197
Weight (g): 250
Usable collets (mmφ): 0.8 (Model 483) / 1.6 (Model 482) / 2.4 (Model 481) / 3.2 (Model 480)
Standard included collet (mmφ): 3.0 / 3.2
*Collets (mmφ) 0.8/1.6/2.4 are sold separately.
No-load speed (min-1): 5,000 to 28,000
Attached collet (mm): 3
Accessories: Yes
Power supply (V): 100V (50/60Hz)
Rated voltage (V): D.C. 7.2 (built-in lithium-ion battery)
Standard accessories: Sanding band, cut-off wheel, mandrel, felt polishing wheel, polishing compound, engraving cutter, silicon carbide grinding stone, stainless steel brush, high-speed cutter, wrench